Oct 8

Written by:
10/8/2011 6:39 PM 

11/1/2011: With the initial fitting of the lower DU, the LCD prevented the throttle qudrant from sliding in place. So I had to cut a 1/2" (approx) notch in the back wall of the CDU stand. Synoptic software shown is Pro MFD 777 Collection.

 

10/8/2011: The 777 MFD frames don't natively fit my classic 767 CDU bay, so some modifications had to be made. I turned to my trusty Dremel tool yet again and proceeded to cut away any piece of metal material that was causing interferance, including two stubborn screws that were holding the center support in place. Quite a bit more cutting will be necessary to allow the screen to fit properly.

 

Click Here for More Photos of the CDU stand restoration